How to restart your 3M / Par G5 and XT-1 Drive-Thru System Base Station

G5 - Reboot Base Station

Much like all electronics like home routers and computers, there is something to be said for turning it off and on again. 

The G5 and XT-1 systems are very similar in the rebooting process.

Here are the steps to reset the base station. 

1.  Locate the screws at the bottom of the unit. You might need a flathead screwdriver to loosen these. 

3M / Par G5 Base Station Remove Screws
2. Once the screws are removed lift from the bottom and the lid should come off.

3M / Par G5 Open Base Station From the Bottom
3. Once the cover is off you should see the power cable on the left hand side. Simple unplug the unit, count to 10 and plug it back in.

3M / Par G5 Base Station unplug the power cable
4. Once the unit has rebooted put the cover back on and screw the screws back in.

There you go!




Toll Free: 1-800-263-4996
Telephone: 905-332-4996
Web: soundproducts.ca
Sales: sales@soundproducts.ca
Support: support@soundproducts.ca

    • Related Articles

    • PAR G5 How to remove headsets to your base station

      From time to time you will have to remove headsets from your system. This process is fairly easy. In this article we will show the steps to remove a headset from your drive-thru system. ​   How to remove your headset make sure the headset is turned ...
    • PAR G5 - How to configure a greeter

      Setting up your greeter on the G5 base station is simple process. The greeter stores an audio message that will be played once a vehicle arrives at the outer post. In this article, we will discuss how to setup said greeter for your business. How to ...
    • PAR G5 How to connect headsets to your base station

      Headsets have to be configured with your base station before the headset can work with your drive-thru system. In this article we will cover the steps setting up your headset to work with your base station. ​   How to program your headset make sure ...
    • XT-1 - How To Check Volumes on a Base Station

      Press the mode button on the keypad Press 1-2-3-4 On the screen the customer will see user ID=1 (this indicates a successful login) Press the mode button 4 times to reach System Menu The first option will be Drive Thru Volumes Press enter to go into ...
    • G5 - How To Check Volumes on a Base Station

      Press the mode button on the keypad Press 1-2-3-4 On the screen the customer will see user ID=1 (this indicates a successful login) Press the Enter button (this will take you to the main menu which will have 2 options) System Menu Greeter Menu Cursor ...